Elite Greenhouses TITAN 1200, Instructions & Illustrations

Page: 21 / 32

3. Now stand up the door end assembly and repeat the above procedure.
4. Stand up the other side frame and repeat the operation outlined in 1 and 2 above at both corners.
5. The bottom cill of the sides attaches to the corner bars in a similar way. Undo the nuts and bolts
inserted in the gable end assembly, move the cill under the corner bar so that the elongated hole in
the vertical flange of the side cill lines up with the bolt slot in the corner bar. Move the bolts down
the slot into the slotted hole, put a nut on and tighten up, ensuring that the corner bar is pushed right
down into the angle of the cill. Do the same at the other 3 bottom corners.
6. The ridge bar is fitted
next, but first you must
thread the glazing beading
into the 2 grooves on the
ridge.
(Key point). Lift the
ridge bar up to the apex and
standing on a pair of sturdy
and safely placed stepladders push the ridge into the small gap between the roof corners so that the
2 flanges which form the angle of roof are tight up against the inside edge of the corner bars. Ensure
the vertical part of the ridge is outside and pointing outwards. Undo the nuts and bolts previously
inserted during the gable end assembly and push them upwards into the slotted holes of the ridge.
Tighten all nuts.
7. The roof bars can now be attached to the structure but first you must slide the glazing beading
into the bars and trim to suit.
(Key point). Attach the bars firstly at the ridge, sliding a bolt into the
bolt slot of the roof bars and placing the bolt through the holes in the
flanges of the ridge. Put a nut on and immediately prior to tightening
ensure that the roof bar is pushed up hard against the ridge. Do not
attach the bottom of the bars to the eave until all the roof bars are bolted
to the ridge.
(Key point ).