62
English
Caution:
When fi tting the blades, always po-
sition the nuts on the left-hand side
of the blade plate. By applying this
installation method, the nuts will
be automatically tightened during
shredding by the turning direction
of the blade shaft. As a reminder:
“Always position the nuts on the
belt pulley side.”
11.5.3.2 To replace a shredding knife, proceed as follows:
• New RESIST/10TM sets are available form your ELIET Dealer
under the following Part Number: BU 401 301 000
• Disassemble all bolts (M10) that secure the blades. Always use two ring spanners with long
handles to unscrew these bolt attachments. (A/F 17)
• Do not pull away the blades using your hands but use a self-grip wrench.
• It is useful to put a wedge (screwdriver) in-between the blade disks to ensure it is easy to
release them.
• First remove any dirt between the blade plates before you insert a new blade. To do so, use a
stripping knife.
• Use the same procedure as for reversing the blades:
Group 1:
Check that the rear of each blade faces towards the wall
(B)
of the shredding chamber.
Group 2:
Each blade that is mounted on a fl uted part of a blade disk must face the axis line of
the blade shaft with its front side
(F)
.
• On replacing shredding blades, always fi t new bolts and nuts.
• When refi tting the shredding knives check that all bolts are tight (torque loading: 76 Nm).
• When refi tting the bolts in the discs, always make sure the nut is located on the left side of the disc.
As a reminder: “All nuts in the blade shaft must always be positioned along the side of the pulley”.
(F)
(B)