28
English
Caution:
If the engine refuses to start, do not allow it to run for too long a period of
time (>5 sec). This could make the starting motor burn out. Investigate
what has caused the problem.
Caution:
If the shredding chamber is still full of chippings, the engine will encounter a lot
of resistance and it will be diffi cult or impossible to start the engine. Therefore,
always empty the shredding chamber before starting the engine. (Read AP.A-P3 )
Warning:
The drive shaft for the blades is directly driven by the engine. These blades
are permanently connected to and driven by the engine. This means that the
machine becomes dangerous as soon as the motor starts running. The engine
must therefore be switched off immediately if you encounter a situation
where you no longer have control over the work.
B. Stopping the machine:
Caution:
Always allow the shredding chamber to fully empty since this
will avoid problems when you start the engine again.
• Move the black feed roller handlebar in the STOP position.
(6)
• Move the throttle control lever
(1)
to low speed.
• The ABM pilot light will come on.
• Turn the ignition key
(3)
to the 0 position
and remove from the ignition switch.
• Store the key in a safe place away from children
and unauthorised persons.
For your information:
If the engine has been switched off, it is diffi cult to move the machine and,
therefore, you should ensure that the machine is at the required location before
switching off the engine.