6
4) Assembling the base part (C) and
the rail covers (G)
Fig.7
Place the wheels of both sides of the
base (C) on the rails on the
worktable (Fig.7).
Check whether the wheels can be
rolled steadily on the rails.
Insert the bottom of the rail covers into
the gap below the both sides of the rails
respectively in the direction of the arrow
(Fig.7)
.
5) Assembling illumination part (A)
Loosen the illumination arm couple
bolt (14).
Rotate the brass shaft sleeve so that
the red mark is 30 to 90 degree
from the limiting board (Fig.8).
Fig.8
Loosen
the
setscrews
in
the
illumination
arm
with
the
screwdriver (V). Aim the assembly
hole of the illumination arm at the
brass shaft sleeve with care then put
down, let the shaft keeping close to
the
bottom
surface
well
and
simultaneously the two red marks
stretch in one line (Fig.9).
After the two red marks accurately
aligned, retighten the setscrews
(Fig.9).
Fig.9
6)
Assembling
the
Converging
Binocular Tubes (B)
Match the groove on the binocular
tubes with the pin on the microscope
body. (Fig.10)
Fig.10
Fasten the fixing screw on the body
to the microscope.
Attention: Avoid touching any
lens surface.
7) Assembling the breath shield (E)
Remove the breath shield fixation
screw from the microscope arm.
Pass the removed screw through the
hole of the breath shield then
re-screw it into the arm (Fig.11).
