About Discarding
Do
not
discard
in
family
garbage!
Handling and recycling: you have to deal with the iron correctly
according to local laws and regulations.
FAQ
FAQ
：
1. Why the temperature of the new T12 solder tip is jump?
Because the inside heating core of the new T12 solder tip did not go through the high
temperature, so the first time to use will be a bit of temperature, generally without special
treatment, the normal use of 1-2 days after the basic will not bounce. Such as the need to
immediately effective, the general proposal to adjust the temperature to 380
℃ ℃
-400
, side of the solder tip to the tip of tin, burning 5-10 minutes after the shutdown,
until the solder tip of the cooling and then re-boot! ( if 1 times no effect, then can be
repeated 2-3 times). T12 is pulsating temperature warming, even if the display temperature
is flashing, the tip of the real temperature is completely stable.
T12 jump temperature also are connected with the temperature control board
of procedures, power of electrostatic and if it connect the ground. 2. What the
problem of attention when we use the T12 first time?
T12 tip heating speed is very fast, when the new solder tip connect the electricity, it
must be tinput immediately to the solder tip, for protection, due to heating up fast, just
need 6-10 seconds, no have more time to you for preparetion. so the important is
prepare the items which will be welded, and finally boot power, and each welding gap or
the end, should be more on the tin to protect and then shutdown, so it can avoid to tin the
new sold tip is difficult, especially the T12 tip type of iron, such as T12-I / T12-IL / T12-BL
/ T12-ILS and so on!
3.What are the precautions for using the T12 tip?
a. If can use low temperature, then do not high temperature: T12 is constant temperature
control, the general recommended working temperature control between 300
℃ ℃
~ 380
, higher than 380
℃
damage the coating of solder tip and cut down the PTC
life!
b. Do not dry: the first time to use solder tip, should be wrapped while heating a layer of
tin. If it's without work, at once shutdown!
c. Diligent to clean: before shutting down, use a wet sponge or detin the ball to remove the
