elero RolMotion/D+ M-868, Operating And Assembly Instructions Manual

Page: 5 / 12

Damage to the blind due to incorrect travel direction.
► The assignment of the UP/DOWN direction of rotation
with an elero radio transmitter must be checked after the
programming process.
Connect only in de-energised state. To do this, switch
the drive cable so it is de-energised.
1 Press locking mechanism on the motor cable plug to-
wards the cable using a suitable screwdriver.
2 Pull out the plug.
3 Insert the motor cable plug until the lock engages.
Removing and inserting the motor cable plug
Delivery
condition
Removing plug Inserting plug
Fig. 4 Removing and inserting the motor cable plug
5.3 Connection example for RolMotion/D+ M-868
230 V/50 Hz
(3)
(2)
(1)
Fig. 5 Connection diagram for RolMotion/D+ M-868
230 V/50 Hz and cable assignment when using
Hirschmann plug connection STAS-3 (with bridge)
Important
The motor controls in the Open and Down/Closed travel
directions must be locked against each other.
A switching time of at least 0.5 seconds must be observed.
5.4 Commissioning
Important
The drive is in commissioning mode when delivered.
► The end positions must be adjusted using the elero
assembly cable (see Fig. 6) or an elero wall or hand-held
transmitter (see Fig. 7).
► The assembly cable may only be connected to commis-
sion the drive and for adjustment operations
→
1
→
2
→
3
5.4.1 Connection for assembly cable
%ODX1HXWUDOOHLWHU
6FKZDU]
%UDXQ
*UQJHOE
HOHUR HOHUR
:KLWHQHXWUDOFRQGXFWRU
%ODFN
5HG
*UHHQ
Fig. 6 Connection for assembly cable
► Switch on mains.
► You can now set the end positions with the elero
assembly cable.
5.4.2 Radio connection (transmitter operation)
%ODX1HXWUDOOHLWHU
6FKZDU]
%UDXQ
*UQJHOE
HOHUR HOHUR
:KLWHQHXWUDOFRQGXFWRU
%ODFN
5HG
*UHHQ
Fig. 7 Radio connection (transmitter operation)
► Connect cable wires “UP”
and
“DOWN/CLOSE” together
to phase L (outer conductor).
► Switch on mains. The drive buzzes and travels upwards
and downwards for a short time.
The drive is in radio mode.
Teaching or deleting the transmitter, fixing or deleting the
blind positions: see instructions for the corresponding hand-
held transmitter.
5.4.3 Operation in non-radio mode
Important
If the drive is to be operated in non-radio mode, follow
the instructions for the RolMotion/D+ M (item
no. 138251201).
5.4.4 Automatic configuration of end positions
Important
To use travel profiles, the upper and lower end positions
must first be set.
Automatic teaching of end positions
1 Connect the electric power in accordance with
section 5.2.
2 Check for functioning: If necessary, change or swap
the assignment of the direction buttons for the operat-
ing switch/push button.
The drive switches off automatically when the (upper or
lower) limit stop is reached.
The teaching process is completed due to subsequent
travel of the shutter.
5.4.5 Changing/deleting the end positions
It is not possible to change or delete individual end posi-
tions. This is always done in pairs (upper and lower end
position simultaneously).
© elero GmbH EN | 5
Assembly | Electrical connection | Relief function