elero Insolis 4, Operating Instructions Manual

Page: 5 / 27

3
General
EN
1 General
1.1 Information on the Assembly Manual
The contents structure is based on the life stages of the linear actuator (herein-
after referred to as "device").
The manufacturer reserves the right to make changes to the technical data
stated in this Assembly Manual. In individual cases they may deviate from the
respective device version without the information being categorically changed
or losing validity. The current state of the technical data can be obtained from
the manufacturer at any time. Any claims arising herefrom may not be asserted.
Deviations from the text and image statements are possible and are dependent
on the technical development, equipment and accessories of the device. The
manufacturer shall provide information on any deviant details on special versi-
ons via the sales documentation. Other details shall remain unaffected by this.
1.2 Standards and guidelines
During the design of the device the fundamental requirements for health and
safety were applied and provision was made for the appropriate legislation,
industrial standards and regulations.
The safety element is confirmed by the Declaration of Incorporation (see chapter
"Declaration of Incorporation"). All information on safety in this Assembly Manual
refers to legislation and regulations currently valid in Germany. All information in
this Assembly Manual must be complied with at all times and to the full extent.
In addition to the safety notices in this Assembly Manual, the regulations appli-
cable at the place of installation with regard to accident prevention, environment
protection and occupational safety must be observed and adhered to. The gui-
delines and standards for safety evaluation can be found in the Declaration of
Incorporation.
1.3 Intended use
The device is intended for use in solar tracking systems. Its purpose is position
adjustment in solar tracking systems. Other fields of application must be agreed
in advance with the manufacturer.
The device must not be used in areas where there is a risk of injury to personnel
or in rooms in potentially explosive environments.