§ Children should be supervised to ensure
that they do not play with the appliance.
Preparation:
§ Do not allow children to operate this
equipment
§ Do not operate this equipment in the vanity
of bystanders
§ Wear ear protection and safety glasses at all
times while operating
§ Avoid wearing clothing that is loose fitting or
that has hanging cords and ties
§ Only operate the machine the machine in
open space (e.g. Not close to a wall or other
fixed objects) and on a firm, level surface § Do
not operate the machine on a paved or gravel
surface, where ejected material could cause
injury
§ Before starting the machine, check that all
screws, nuts, bolts, and other fasteners are
properly secured and that guards and screens
are in place. Replace damaged and
unreadable labels
Operation:
§ Before starting the machine, look into the
feeding chamber to make certain, that it is
empty
§ Keep your face and body away from the
feed intake opening
§ Do not allow hands or any other part of the
body or clothing inside the feeding chamber,
discharge chute, or near any moving part
§ Keep proper balance and footing at all
times. Do not overreach. Never stand at a
higher level than the base of the machine,
when feeding material into it
§ Always stand clear of the discharge zone
when operating this machine
§ When feeding material into the machine be
extremely careful that pieces of metal, rocks,
bottles, cans or other foreign objects are not
included
§ If the cutting mechanism strikes any foreign
objects or if the machine should start making
any unusual noise or vibration, shut off the
power source and allow the machine to stop,
disconnect the spark plug wire from the spark
plug ( electric unit disconnect from supply)
and take the following steps:
1. Inspect for damage
2. Check for and tighten any loose parts
3. Have any damaged parts replaced or
repaired with parts having equivalent
specifications
§ Do not allow processed material to build up
in the discharge zone; this may prevent proper
discharge and can result kickback of material
through the feed intake opening
§ If the machine becomes clogged, shut of the
power source and disconnect the spark plug
wire from the spark plug (electric unit
disconnect from supply) before clearing debris.
Keep the power source clear of debris and
other accumulations to prevent damage to the
power source or possible fire. Remember that
operating the starting mechanism on engine
powered machines will still cause the cutting
means to move
§ Keep all guards and deflectors in place and
in good working condition
§ Do not tamper with the power source
governor settings; the governor controls the
safe maximum operating speed and protects
the power source and all moving parts from
damage caused by over speed. Seek
authorized service if a problem exists.
§ Do not transport this machine while the
power source is running
§ Shut off the power source and disconnect
the spark plug lead (electric unit disconnect
from supply) whenever you leave the work
area
§ Do not tilt the machine while the power
source is running
Maintenance and storage
§ When the machine is stopped for servicing,
inspection, or storage, or to change an
accessory, shut off the power source,
disconnect the spark plug wire from the spark
plug (electric unit disconnect from supply),
make sure that all moving parts have come to
a complete stop and, where a key is fitted
remove. Allow the machine to cool before
making any inspections, adjustments, etc
§ Store the machine where fuel vapor will not
reach an open flame or spark. For extended
storage periods, run the unit dry of fuel. Allow
the machine to cool before storing.
§ When servicing the cutting means be aware
that, even though the power source will not
Summary of Contents for BVT50-159CC
