1. Description of the measuring system
Press
ON/OFF button
to switch the gauge ON or OFF.
Press
Function key
CAL to start the calibration procedure.
Press
Function key
MENU to call the main menu.
Press
Function key
STAT to call the statistics menu.
The
command and navigation key block
has the following
functions:
Press OK to confirm settings or select menu items.
Press ESC to abort actions, to quit submenus or to navigate
through a batch.
Use ARROW up/down keys to navigate through a menu or to
change settings.
ESC and OK keys assume various functions according to the
currently active menu.
2. Insert batteries and connect sensor
Take gauge and batteries from the case.
Loosen the screw of the battery compartment to open the battery
compartment lid (e. g. by using a coin).
Insert the batteries into the battery compartment.
Respect polarities (as shown below).
Close lid and tighten screw.
Above the battery compartment screw, a connection for fixing the
hand-strap is located.
The MiniTest 740 can be used with internal or external sensor.
See mounting instructions section 2.1 of the operating manual.
English
Graphics display
Infrared-interface
(IrDA)
On/off button
LED, green to confirm
acquisition of readings,
red to indicate if limits
have been exceeded
Function keys
Command and
navigation key block
Connection for hand strap
Coupling ring
Prism for large curve
radii and large surfaces
Prism for
small curve radii
