Elektron Octatrack DPS-1, User Manual

Page: 98 / 104

A-10
Appendix B: EFFECTS REFERENCE
ECHO FREEZE DELAY
The delay adds echoes to the affected signal. The special echo freeze functionality makes it possible to
repeat a portion of a sound.
DELAY MAIN
TIME controls the delay time of the delay loop.
The actual delay time is relative to the current
tempo, and it is measured in 256th notes. For
instance, for a one beat delay (four 16th notes)
delay time should be set to 64.
FB controls how much of the delay output
sound will be fed back into the input of the
delay. Using the delay feedback you can make
delays with several or infinite echoes.
VOL sets the main volume of the delay output.
BASE controls the high pass filtering of the
signal from the delay feedback loop.
WDTH controls the low pass filtering of the sig-
nal from the delay feedback loop, relative the
BASE parameter.
SEND controls how much of the signal that will
be sent to the delay.
DELAY SETUP
X sets if the delay will act as a ping-pong delay
or not.
TAPE sets the mode of the delay. An ON set-
ting will make the delay interpolate between
delay times when the
TIME parameter in the
DELAY MAIN page is changed. An OFF set-
ting will not interpolate between the delay
times when the
TIME parameter is changed.
DIR sets the how much of the dry signal that
will be mixed with the delay signal. A min set-
ting will make only the delay signal be heard.
SYNC controls whether the delay should be
tempo synced or not.
LOCK controls the feedback behavior of the
delay. When set to 1 it will override certain
parameters and give them other values. The
SEND parameter of the DELAY MAIN page will
be set to 0 and the DIR setting to 0 and FB to
100. This is handy when using the delay as a
repeater.
PASS controls how the signal will be routed
when the LOCK setting is active. A setting of 1
will send the direct signal to the LOCK . A set-
ting of 0 will hinder it from being passed to the
LOCK .