Elektron MULTIMIG 400puls, Operation Manual

Page: 9 / 20

9
12 Menu Structure
Main Level Level 1 Level 2 Remark
Gas pre-flow 0 – 10 sec.; not in electrode mode
Start current 20 % – 200 % of the welding current
Start current time 0 – 10 sec.; not in 4-stroke mode
Twin pulse frequency 0,5 – 5 Hz; only in Twinpulse mode
Twin pulse current change 5 – 50 % of the welding current; only in Twinpulse mode
Twin pulse relation 20 % – 80 %; only in Twinpulse mode
Welding current Adjustment range depends on the selected material-wire-
gas combination
Downslope 10 – 990 A/sec.; not in electrode mode, only when downs-
lope = on
Final current 10 % – 100 % of the welding current; not in electrode mode,
only when slope = on or in 4-stroke
Final current time 0 – 10 sec.; not in electrode mode, only for slope = on
Wire burnback time 20 % – 300 % of the programmed value; not in electrode
mode
Gas post-flow 20 % – 200 % of the programmed value; not in electrode
mode
Arc length correction 60 % – 140 % of the programmed value
Inductor effect 20 % – 200 % of the programmed value; only in normal
mode (short arc)
+/- 40% in manual mode (see “Manual mode” on page 11)
Arc dynamic 0 % – 100 % of the programmed value; only in electrode
mode
Job selection, indication of
set and job name
Set and job name are indicated only in Tiptronic mode
upon actuation of the “TT Enter” push-button 47 or the “Tip-
tronic” push-button 49
Edit mode for set and
job name
Move the cursor with the and push-buttons 51 ;
change the character with the pushbuttons 48 (+) and 44 (-
)
Extras 1Machine data Operating system Master Version number, operating system Master
Operating system Process Version number, operating system process
Operating system DMRs
Version number, motor assembly (-ies)
Welding program version Version number, welding programs
Operating hour counter Indication of the welding duration in h, min, sec
Configuration Machine type and the recognized power module (with max.
current ) are indicated alternately
2 Diagnosis Last error message Indication of the last three error messages from the error
memory (0 = last error, 2 = oldest error)
Module temperatures Temperatures of the power modules in °C
Operating voltages Indication of the operating voltages (15 V / 24 V) of the
E-assembly DP-MAPRO
Flow rate, cooling unit Indication of the coolant flow rate in l/min
3 Language Selection of the menu language
4 Display contrast Contrast setting of the LCD display
5 Mode cooling system 0 normal cooling unit switches on, as soon as an arc is ignited
1 on cooling unit runs constantly
2 off cooling unit is deactivated
6 Lock function 0 All free
1 Welding current, mode and Tiptronic on/off free
2 Tiptronic on/off, job selection free
3 All locked except menu selection, gas and pump test
7 Arc lenght control voltage correct arc lenght with rotary pulse encoder 58
wire correct wire speed with rotary pulse encoder 58
8 Robot interface Menu item is only visible when the machine is equipped
with a robot interface (further details about setup/configura-
tion see operation manual INT)