6
Necessary Procedures and Safety Warnings
Prior to Using
ThruScan
Prevent direct light exposer to the infrared sensors (see Sec. 6.10) of
your
ThruScan
WTMD.
Leave minimum 1m of distance between your
ThruScan
and any
objects such as metal doors, X-Rays, turnstiles, as such.
Do not place any covers, plating or loads that would induce weight
over your
ThruScan
unless being recommended by the factory.
Do not drill any holes on the panels of your
ThruScan
under any
circumstances.
Your
ThruScan
is secured both by a mechanical lock and an
electronic PIN CODE as a precaution against unauthorized people. Do
not share your password. Contact the factory if you forget the
password.
Assemble your
ThruScan
on a horizontal and flat floor. Make sure it
is fixed firmly to the floor.
Do not assemble your
ThruScan
on an unstable or moving floor
surface.
Do not let unauthorized persons to intervene
ThruScan
’ s electronic
units. Contact your dealer or the factory for an authorized service
person.
Use soft, damp clothing to clean your
ThruScan
. Always unplug your
equipment during cleaning.
Never operate your equipment through mains without norm ground
ThruScan
is designed to operate between 70~270 VAC / 50Hz~60
Hz.
