51
2
1
2
1
*How do I clean it?
You may clean it with dry or damp clothing and/or with anti-static fluids for electronic
equipment. Never clean using direct water or chemicals, detergents etc…
See section 8.1
9.2 INSTALLATION PROBLEMS
*What kind of equipment do I need for mounting the WTMD?
All tooling and accessories for the mounting are included. You can mount without any extra
equipment except an electric stroked drill. See section 2.2
*May I fix it from the top or the sides to other utilities?
This is an electronic equipment, so no procedures can be made such as cutting its panels or case or
drilling it in order to stable or any other means.
Otherwise warranty will be void. When necessary to
fix your WTMD from the top or the sides, it would be best to fasten gently without harming it.
*Is it possible to use WTMD without fixing it to the ground?
It is not advised to operate WTMD which will be confronted to constant hits and bumps, without
fixing it to the ground. Serious bumps may cause it to fall down.
*Would relocating the WTMD cause any failure?
Following the mounting and dismounting procedures in the user’s manual would not cause any
failure.
*Are there any restrictions for the place of the mounting?
You should mount your WTMD as in the necessary distance, away from moving metal objects. This
distance should at least be 1 meter depending on the type of the moving metal.
Also the environmental conditions should match with the security class of your WTMD. See section
2.1
*Is it possible to have the mains input from Top to Bottom or Bottom to Top
?
The standard position of the mains input for
ThruScan
WTMDs is at the back cover of the control
unit. If the desired location for the mains input on the WTMD is clarified prior to the order, the
mains input may be arranged to be on the desired point if allowed.
* How can I operate multi WTMDs together?
To operate your WTMDs in parallel, you should follow the instructions in Section 6.13 If there is no
specific provided cable then a twin cable should be connected from outputs 1 and 2 via the proper
connectors between the sockets of the
ThruScan
s as shown in
Section 3.7.
Do not forget to turn OFF the switch on the main board of the slave
WTMD. See Section 6.13
* I want to control my WTMD inside the building with the SRC-Remote Control SCADA
Software. How should I arrange the connection?
