ELEKTRA
Heating Cables
Operation
Holes can be drilled in the heated surface after
the exact arrangement of the heating cables has
been determined (based on the as-built docu-
mentation or measurements taken with a special
detector).
Caution:
Make sure 240 VAC is supplied to 240 VAC
heating cable.
All electrical work must be done by a qualified
licensed electrician in accordance with local
building and electrical codes, and the National
Electrical Code (NEC), especially Article 424,
Part IX of the NEC, ANSI/NFPA70 and Section
62 of CEC Part1.
Pay careful attention to the amps to make sure
your controls, circuit breaker panel, and wiring
will have the proper capacity. Design every-
thing to handle 125 percent of heating mat
load (complete product listening table).
!
24
