AUTO−RUN mode:
In AUTO-RUN mode, the NJ174 goes through all the
built-in programs in turn. To select AUTO−RUN Press the
MODE button repeatedly until
AUTO
is shown on the
display.
In AUTO-RUN mode the LED chase speed, flash
frequency, running speed and retention time can be set
as above. The time between program changes can also
be set. Press SETUP repeatedly until the first character
of the display shows
n
. Then use the UP and DOWN
buttons to select the time between program changes.
The run speed, fade time and flash frequency can be
adjusted as shown above.
SOUND mode:
To select SOUND mode, press MODE repeatedly until
SU
is shown in the first two characters of the display. In
SOUND mode, only the sensitivity can be set.
Press SETUP to change the sensitivity.
SU
will be shown in the first two characters of the
display, and the sensitivity will be shown in the last two
characters of the display. Press UP or DOWN to adjust
the sensitivity.
SLAVE mode.
To select SLAVE mode, press MODE repeatedly until
SLAu
is shown in the display.
In slave mode, the NJ174 will copy the colours and
movements of any other unit to which it connected by a
DMX cable. Connect a DMX lead from
DMXout
of the
Master luminaire to
DMXin
on the slave. If there is more
than one slave connect a DMX lead from
DMXout
on
Page 5
