Page 12 of 80
M8024 Issue 3.4
For use with master product
software V3.5.1.8 and above.
5.2.3.
Connect the PSU to the mains supply using the plug and lead set supplied with the Integrity 10.
Turn on the mains power supplying the PSU.
6. ENVIRONMENTAL PROTECTION.
6.1. Maximum consideration has been given to environmental issues within the design and manufacturing
process of this product without compromising product performance and value.
6.2.
Packaging materials have been selected such that they may be sorted for recycling.
6.3.
At the end of your product and accessories life, it must not be discarded as domestic waste. Ref: EU
Directive 2002/96/EC on Waste Electrical and Electronic Equipment Directive (WEEE).
*
Please contact your distributor / supplier for further information. For end users outside of the
EU consult applicable regulations.
6.4. This product should only be dismantled for recycling by an authorised recycling company.
This product and accessories must be accompanied by a completed
Decontamination Certificate prior to any disposal.
Copies of the Certificate are available
from your distributor of Bibby Scientific products, or you may copy and enlarge from
‘Appendix A’ of this instruction book.
6.5. Battery Disposal.
This product contains a Lithium Cell button Battery (CR2032) on the control PCB
located in the front Pod of the Integrity 10 Unit. All batteries must be disposed of in accordance with
regulations.
Do Not dispose of product in a fire as batteries may explode.
6.6. EuP and Eco Operation.
The chiller and Integrity 10 complete the full reaction system. For optimised operation observe the following:
Do not set the chiller to operate at temperatures below 5°C.
Do not use a chiller larger than the specification required.
See recommended chillers section 11.
Parts and accessories.
When finishing an experiment at an elevated temperature do not chill the cell prior to cell turn off.
To avoid causing stress and shortening the life of the Peltia devices avoid crash cooling cells from
elevated temperatures.
Only operate cells that are in use.
Cells that are chilled below 0°C and operated at such temperatures for very extensive periods will
cause ice formation. Excessive ice prevents the cell from operating efficiently. Avoid such
operation when possible.
Avoid unnecessary use at either ends of the temperature spectrum.
Turn off the unit at the PSU I/O button when the Integrity 10 is not in use.
Please return all replaced cell assemblies to the distributor / manufacturer for green disposal.
Keep chilled water hose length as short as reasonable possible and insulate the hoses to prevent
temperature losses and the accumulation of condensation.
Bibby Scientific’s Electrothermal branded product range is registered with the Environment Agency under the name of as
Electrothermal Engineering Limited as being a producer of WEEE (Waste Electronic and Electrical Equipment) through b2b
Compliance
,
an authorised waste collection compliance scheme.
