Electrolux ProClean RealLife EDW1xxx-2G Series, Service Manual

Page: 30 / 57

SOE/PR 30 599 72 48-93
9.2 Description of the alarms
9.2.1 “i00” code family: Low mains voltage
The electronic board makes sure the dishwasher operates within certain voltage limits. If - during a cycle -
the voltage drops below the lowest limit, the electronic board suspends all loads and interrupts the cycle
under way. The “i00” alarm is then triggered. The lowest main voltage threshold is 180 Volt.
If the voltage goes back to over 186 Volt, the electronic board cancels the error status and the cycle
resumes. The “i00” alarm is also deleted.
If the mains voltage continues to exceed the maximum threshold, the electronic board does not do anything.
IMPORTANT: the “i00” alarm is not stored and cannot therefore be read in Service Mode.
9.2.2 “i10” code family: Water tap closed
9.2.2.1 “i10" code – during static filling
This alarm code is used to display problems with the water inlet tap closed at the beginning of the
programme. It is set up to detect problems during the static water filling. A drain phase is performed before
the error is displayed to the user.
- Acoustic signal and visual alarm, depending on the appliance customisation; the programme can be
restarted.
- The water level defined is not reached within the time limit set.
- The time limit set starts when the fill solenoid valve is opened.
- The time limit set is reset when the fill solenoid valve is closed.
- The water will first be drained before an error is displayed to the user.
- Time limit set: Normal 90 sec; Test cycle = 30 sec (times could differ as they are defined in the
washing cycle specifications).
9.2.2.2 “i11" code – during dynamic filling
- Acoustic signal and visual alarm, depending on the appliance customisation; the programme can be
restarted.
- The water level defined is not reached within the time limit set.
- The time limit set starts when the fill solenoid valve is opened.
- The time limit set is reset when the fill solenoid valve is closed.
- The water will first be drained before an error is displayed to the user.
- Time limit set: Normal 120 sec; Test cycle = 60 sec (times could differ as they are defined in the
washing cycle specifications).
9.2.3 “i20” code family: Draining problems
- Acoustic signal and visual alarm, depending on the appliance customisation; the programme can be
restarted.
- The level switch restore point is not reached within the time limit set.
- The time limit set starts when the drain pump is activated.
- The time limit set is reset when the drain pump stops normally.
- Time limit set: Normal 90 sec; Test cycle = 60 sec.
9.2.4 “i30” code family: Aqua Control
9.2.4.1 “i30” code
- Acoustic signal and visual alarm, depending on the appliance customisation; the programme is
restarted automatically in this alarm condition.
- If this alarm condition occurs, the drain pump is activated.
- Time limit set: 10 sec.