18 www.electrolux.com
panel hooks, until the thickness of
the sponge between the body and
the panel’s outlet has been reduced
to about 4~6mm. The edge of the
panel should contact with the ceiling
well. (Refer to Fig.20) Malfunction
described in Fig.21 can be caused by
inappropriate tightness the screw. If
the gap between the panel and ceiling
still exists after fastening the screws,
the height of the indoor unit should
be modied again. You can modify the
height of the indoor unit through the
openings on the panel’s four corners,
if the lift of the indoor unit and the
drainpipe is not inuenced.
Fig.20
Fig.21
CAUTION!
Screws must be tightly fasten.
Fig.22
Hang the air-in grid to the panel, then
connect the lead terminator of the swing
motor and that of the control box with
corresponding terminators on the body
respectively.
Relocate the air-in grid in the procedure of
reversed order, install the air-in grid.
3.6
The installation of ventilation
motor and ventilation pipe (if
necessary).
1.
Using a tool to knock off the
prepunching hole. (Refer to Fig.23)
2.
Four screw hole reserved for
installation. (Refer to Fig.23 )
Fig.23
Panel
foam1
Inlet air
Body
Ceiling Panel foam2
Panel foam
Panel sealing
foam
Panel
Air plate
Outlet air
Ceiling
Leakage
Dew
Ceiling
Hexagon nut
Horizontal
adjust ment
pre-punching hole
Four screw hole
Summary of Contents for EXC09JEIWI
Page 254: ...ZZZ HOHFWUROX FRP VKRS ...
