9
5. Screw the middle hinge
○
6
and the
alternative left top hinge
○
9 included in the
fittings,
on the left hand side of cabinet. (Fig.
2 & 3)
6. Unscrew and transfer the lower hinge bracket
○
5 to the opposite side. At the same time
transfer the stopper pin
○
4 to the opposite
designated position of the lower hinge
bracket. (Fig. 1)
7. Relocate the upper and lower door shaft
assembly to the designated positions.
8. Set the upper glass door to the designated
position and install the two lock screws to
connect the upper door shaft assembly
○
7
with the upper glass door and tighten them
before the door is leveled. (Fig. 2)
9. Set the lower glass door to the designated
position and install the two lock screws
○
1 to
connect the lower door shaft assembly
○
2
with the lower glass door and tighten them
before the door is leveled. (Fig. 1)
10. Remove the handles from the left side of the
doors and install them on the right side.
USE ATTENTION
•
Only store wine in unopened bottles. Always
lay bottles on their side for storage.
•
Do not overload the cabinet.
•
Do not open the door unless necessary.
•
Do not cover shelves with aluminum foil or
any other shelf material which may prevent air
circulation.
•
Should the unit be left empty for long periods
it is suggested that the appliance is
unplugged, and after careful cleaning, leave
the door ajar to allow air to circulate inside the
cabinet
in
order
to
avoid
possible
condensation, mold or odours forming.
OPERATING YOUR
APPLIANCE
This appliance is designed for operation at certain
ambient temperatures. The climate class is
specified on the rating plate.
The appliance may not work properly if it is left for a
long period at a temperature outside the specified
range. For example, placing your unit in extreme
cold or hot conditions may cause interior
temperatures to fluctuate. The range between 5ºC
and 22ºC (41ºF and 72ºF) may not be reached.
Climate class
Ambient room temperatures
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+18°C to +38°C
+18°C to +43°C
NOTE:
Units with no heater will not raise its
internal temperature if the ambient temperature
where the unit is located is lower than the set
temperature.
NOTE:
•
When you use the appliance for the
first time or restart the appliance
after
having been shut off for a long
time,
there could be a few degrees
variance
between the temperature you
select
and the one indicated on the
LED
readout. This is normal and it is
due
to the length of the activation time.
Once the unit is running for a
few
hours everything will be back to
normal.
•
If the unit is unplugged, power lost,
or
turned off, you must wait 3 to 5
minutes before restarting the unit. If
you attempt to restart before this time
delay, the unit will not start.
