8
7. Rotate the door 180° or not for some models
and then relocate the door to the designated
position. Then screw the bottom hinge
assembly on the left designated position and
tighten it after the door is leveled. (Fig. 2)
8. Transfer the handle from the left side of the
door to the right side and reassembly the
ventilation grilles if need.
DESIGN 2 -
1. Remove the glass door by unscrewing the
eight lock screws
○
3
and
○
4
. Be careful to
hold the glass door firmly after removing the
screws and place it on a padded surface to
avoid the risk of damage.
2. Unscrew and transfer the door supporter
○
2
to the opposite side.
3. Rotate the glass door 180°and refit the glass
door to the opposite side. Then screw and
tighten it after the door is leveled.
DESIGN 3 -
1. Remove the door shaft assembly
○
2 by
unscrewing the two lock screws
○
1 . Be
careful to hold the glass door firmly after
removing the screws. (Fig. 1)
2. Gently pull down to remove the glass door
from the right top hinge and place it on a
padded surface to avoid the risk of damage.
Then remove the right top hinge
○
7 . (Fig. 2
& 3)
3. Pop out the cover caps on the left side of
cabinet and use them to
cover the screw holes
on the right hand side.
4. Screw the alternative left top hinge
○
8 ,
included in the fittings,
on the left hand side of
cabinet. (Fig. 3)
5. Unscrew and transfer the lower hinge bracket
○
5 and door supporter to the opposite side. At
the same time remove the stopper pin
○
4 to
the opposite designated position of the lower
hinge bracket. (Fig. 1)
6. Relocate the door shaft assembly to the
designated position.
7. Relocate the glass door to the designated
position. Then screw the door shaft assembly
on the left designated position and tighten it
after the door is leveled. (Fig. 1)
8. Remove the handle from the left side of the
door and install it on the right side.
DESIGN 4 -
1. Remove the lower door shaft assembly
○
2 by
unscrewing the two lock screws
○
1 . Be careful
to hold the lower glass door firmly after
removing the screws. And then gently pull down
to remove the lower glass door from the middle
hinge and place it on a padded surface to avoid
the risk of damage. (Fig. 1)
2. Remove the upper door shaft assembly
○
7 by
unscrewing the two lock screws. Be careful to
hold the upper glass door firmly after removing
the screws. And then gently pull down to
remove the upper glass door from the top hinge
and place it on a padded surface to avoid the
risk of damage. (Fig. 2)
3. Unscrew and remove the middle hinge
○
6 and
the right top hinge
○
8 . (Fig. 2 & 3)
4. Pop out the cover caps and unscrew the middle
fixing plate on the left side of cabinet and install
them
on the right hand side.
