7
Note:
In locations where there is frequent
lightning, it is advisable to use surge protectors.
Do not connect the appliance to the mains
electricity supply by an extension lead. Extension
leads do not guarantee the required safety of the
appliance (e.g. danger of overheating).
The appliance must not be connected to an
inverter and must not be used with a plug adapter
as these can cause damage to the appliance’s
electronic unit.
The cord must rest securely behind the appliance
and not be allowed to lie or hang unprotected.
WARNING:
THIS APPLIANCE MUST BE EARTHED.
INSTALLING THE HANDLE
IMPORTANT:
Do not overtighten the screws & do
not use power tools to install the handle.
DESIGN 1 –
1
2
3
Locate the handle
○
1 over the fixing pins
○
3 of
the door and using the supplied allen key, tighten
the securing grub screws
○
2 to fix the handle.
DESIGN 2 –
1
2
3
4
5
1. Remove the door gasket
○
1
on the side you
wish to install the handle - you can see two
designated holes for handle installation.
2. Install the handle
○
4
tightly as shown above
with two screws
○
3
and flat washers
○
2
provided.
3. Replace the door gasket.
REVERSING THE DOOR HINGE
It is possible to reverse the door on this appliance, if
required.
To do so, follow the steps below:
DESIGN 1 -
1. Remove the adjustable ventilation grille
○
2
by
unscrewing the screws
○
1
and then remove the
ventilation grille
○
4
by unscrewing the screws
○
3
. (Fig. 1)
NOTE:
For some models the step of removing
the ventilation grille is not needed.
2. Remove the bottom hinge
○
5 by unscrewing
the four lock screws
○
6 . Be careful to hold the
glass door firmly after removing the screws.
(Fig. 2)
3. Gently pull down to remove the glass door from
the right top hinge and place it on a padded
surface to avoid the risk of damage. Then
remove the right top hinge
○
10 . (Fig. 3 & 4)
4. Unscrew and transfer pins
○
8 and/or
○
7 of the
hinge plate to the opposite side. (Fig. 2)
5. Pop out the cover caps on the left side of
cabinet and use them to
cover the screw holes
on the right hand side.
6. Screw the alternative left top hinge
○
12 ,
included in the fittings,
on the left hand side of
cabinet. (Fig. 4)
Note: All parts removed must be saved to
do the reinstallation of door.
