Electrolux EWG 10050 W, User Manual

Page: 26 / 40

The door will not open:
●
The programme is still
running.
●
The door lock has not
been released.
●
There is water in the
drum.
●
Wait until the end of
washing cycle.
●
Wait until the pilot light
7.2
goes off.
●
Select drain or spin
programme to empty out
the water.
Malfunction Possible cause Solution
The machine does not
empty and/or does not
spin:
●
The drain hose is
squashed or kinked. (T
Th he e
rre ed d p piillo ott lliig gh htt o off b bu utttto on n 5 5
b blliin nk ks s)
●
The drain pump is
clogged.
E20
●
The Rinse Hold or Night
Cycle option has been
selected.
●
The laundry is not evenly
distributed in the drum.
●
Check the drain hose
connection.
●
Clean the drain pump.
●
Select the Drain or Spin
programme.
●
Redistribute the laundry.
There is water on the
floor:
●
Too much detergent or
unsuitable detergent
(creates too much foam)
has been used.
●
Check whether there are
any leaks from one of the
inlet hose fittings. It is not
always easy to see this
as the water runs down
the hose; check to see if
it is damp.
●
The drain or inlet hose is
damaged.
●
The cap on the
emergency emptying
hose has not been
replaced after cleaning
the pump.
●
Reduce the detergent
quantity or use another
one.
●
Check the water inlet
hose connection.
●
Replace it with a new
one.
●
Refit the cap on the
emergency emptying
hose and place the latter
back in its seat.
The machine fills then
empties immediately:
●
The end of the drain
hose is too low.
●
Refer to relevant
paragraph in “water
drainage” section.
26 electrolux what to do if...
132966740.qxd 16/06/2008 11.11 Page 26