19
Start the Washing Program
1.
Check that the water valve is open.
2.
Start the washing program: Press the button
START/PAUSE. The washing program is started
or it starts after the set time expires.
3
The filling door is not correctly closed if,
when the button START/PAUSE is pressed,
In this case, press the filling door firmly
closed and again press the button START/
PAUSE.
If the time preselection is set:
A set time preselection runs and the remaining time
until the program start is displayed (in each case in
full hours, e.g.
5h
). During this time you can load
washing or change/abort the time preselection.
•
Load washing: Press the button START/PAUSE.
The filling door can be opened. Next, close the
door and again press the button START/PAUSE.
•
Change or abort time preselection: Press the but-
ton DELAY TIMER (Zeitvorwahl, Départ Différé) as
often as necessary until the required time is dis-
played; when the program run time is displayed
(display in minutes, e.g.
126
), the washing pro-
gram starts without delay.
Washing Program Progress
Program Sequence Display
Prior to the start, the program steps chosen are
displayed by the program sequence display. During
the washing program the current program step is
displayed.
Multi-display
The expected time remaining (in minutes) to the end
of the program is shown in the multi-display.
3
The multi-display indicates the estimated
duration, in minutes, of the program. These
timings are estimates and can be varied and
influenced by incoming water temperature,
type and quantity of laundry, out of balance
spin detection and foam detection. During
the program countdown the remaining time
can be recalculated due to any of the above
factors.
– the indicator DOOR (Tür, Porte) flashes
red
– the fault code
E40
in the multidisplay
flashes
– and the indicator MAIN WASH (Haupt-
wäsche, Lavage) flashes.
