You can use the TIMER ON and TIMER OFF
in combination.
example:
To stop operation at 11:00 p.m. and resume operation
(with the same mode and temperature settings) to bring
the room temperature to the desired level by 7:00 a.m.
1. Set the TIMER OFF to 11:00 p.m. during operation.
2. Set the TIMER ON to 7:00 a.m.
The arrow ( or ) between the TIMER ON and the
TIMER OFF indicator shows which timer will activate first.
NOTES:
• You cannot programmed the TIMER ON and TIMER
OFF to operate the unit at different temperatures
or other settings.
• Either timer can be programmed to activate prior
to the other.
Auxiliary mode
Use this mode when the remote control is lost or
not operational.
to turn on
Lift and open the front panel of the indoor unit and press
the AUX. button on the operation panel.
• The red OPERATION lamp on the unit will illuminate and
the unit will start operating in the AUTO mode.
• The fan speed and temperature setting are set to AUTO.
to turn off
Press the AUX. button on the operation panel again.
• The red OPERATION lamp on the unit will turn off.
NOTE:
If the AUX. button is pressed during normal operation, the
unit will turn off.
Combined use of timer on and off
SWING
CLEAN
FAN
MODE
SET/C
1h
DISPLAY
electrolux ESD24HRA & ESD30HRA
maintenance 13
Maintenance
1
2
3
The air purifying filters are packed as an accessory of
this unit. During operation of the air conditioner the
filters remove dust and tobacco smoke from the air
and discharge clean air.
Be sure to turn the air conditioner off and switch off the
circuit breaker before performing any maintenance.
Cleaning the filters
The air filters should be cleaned every two weeks.
1. Turn off the unit
2. Remove the filters
(1) Lift and open the front panel.
(2) Push the air filters up slightly to unlock them.
(3) Pull the air filters down to remove them.
3. Clean the filters
Use a vacuum cleaner to remove dust. If the filters are
dirty, wash them with warm water and a mild detergent.
Dry filters in the shade before reinstalling.
4. Reinstall the filters
(1) Reinstall the filters in the original positions.
(2) Close the front panel.
(3) Push the arrow-marked of the front panel firmly to
lock it in place.
3
Figure B
Figure A
1
2
