8.2.5. EDW 1500 Service function / additional rinsing process
General information
Calling above-mentioned service function
w
Calling the Service Functions is similar with all designs
Calling the function "Additional Wash Cycle"
or key arrangements.
w
Always use the keys S0, S1, S2 and S3 independently
1.
Simultaneously press S1 and S3 and ...
from their program assignment depending on the model.
w
In service function mode, you can ALWAYS call the
2.
... switch on the appliance with ON/OFF switch S0.
"additional wash cycle" by using keys S1 and S2.
Keep keys S1 and S3 pressed simultaneously
Use key S1 to modify
until the 3 acknowledging LEDs LD1, LD2 and LD3 are flashing.
the setting.
( Short-time illumination of LEDs is possible and does not constitute any fault)
w
From works settings, no additional wash cycle is set.
3.
Simultaneously press S1 and S2 until the acknowleding LED
LD1 is flashing. LEDs LD2 and LD3 will go dark.
The current status whether the Add. Wash Cycle is active or not
is signaled in the display. If there is no display
on the model, the value is indicated by LED "End."
1A = Add. Wash Cycle is selected
0A = No Add. Wash Cycle
Switching this function on or off:
w
If this function is activated, an additional wash cycle will
4. / 5.
Any further activation of function key S1 will
ALWAYS be added, except for "prewash extra".
switch the addition alternately on or off.
This will extend program run times up to about 10 minutes.
This additional wash cycle will be executed until the
Leaving the function
function is deactivated again.
After the last activation of function key S1 you can leave the
special program as follows:
After 60 seconds all displays go out automatically, except
LD0 of the ON/OFF key
or
the appliance is switched off by ON/OFF key S0.
Always applicable:
Saving the status settings
In order to call the totality of service functions, always first
Immediately after each input of data, the currently valid status
press the function keys S1 and S3 prior to switching the
will be saved.
appliance on by means of ON/OFF switch S0!
Keep the keys pressed for abt. 4 seconds in order to activate
the function. This procedure is intentionally distinguished
from those for the customer functions.
ATTENTION:
In case of reduced key assemblies
be sure to observe Description Page B 1.
key arrangement
vertically
S1
S2
S3
LD1
LD2
LD3
1
99
S1
LD0
S0
LD0
LD1 LD2
S1 S2
1
99
LD3
S3
key arrangement
horizontally
... automatically OFF after 60 sec
... OFF by actuating ON/OFF manually
S0
LD0
3.
LD2
S2
S0
LD0
LD1
S1
LD3
S3
LD2
S2
S1
LD0
LD1
S1
LD3
S3
S0
LD0
4.
1A
flashing
S0
LD0
5.
1.
S0
LD0
LD2
LD1
LD3
S1
S3
S0
LD0
2.
LD2
LD1
LD3
S1
S3
flashing
LD2
LD1
S1
S2
flashing
LD3
0A
LD1
S1
0A
LD1
S1
flashing
Keep keys S1/S3
pressed for abr. 4 sec.
until LD1-LD3 are flashing
