Electrolux ECG6200, Instruction Book

Page: 93 / 588

g
93
4 Special mode
For setting the water hardness („Set-
ting the water hardness“, page 95) and
the coffee temperature („Setting the
coffee temperature“, page 101), for
starting the descaling program („Run-
ning the descaling program“, page 103)
and for viewing the statistics („Statistic
mode“, page 107), you can switch to a
special mode by pressing the "P" key
(Fig.4). In this mode, you can navigate
by means of the "1 cup of coffee"
,
"2 cups of coffee“ , "Steam“ and
"P“ keys. The respective function in
each case is shown in the display above
the key (Fig. 5):
• «
<
» ("1 cup of coffee" ) and
«
>
» ("2 cups of coffee“ ) are for
"scrolling“
• «
OK
» ("Steam“ ) confirms an item
• «
P
» ("P“) returns to the last level with-
out changing settings.
5 Before using for the first
time
5.1 Setting up and connecting the
coffee machine
0
Place the machine on a suitable hori-
zontal, stable, unheated and water-
resistant surface.
1
Ensure that there is good air circula-
tion. After positioning the appliance
on the work top, leave a space of at
least 5 cm between the surfaces of the
appliance and the side and rear walls
and at least 20 cm above the coffee
maker.
Never install the appliance in environ-
ments where the temperature may
reach 0°C or lower (the appliance may
be damaged if the water freezes).
1 Important! If the coffee machine is
brought into a warm room from a cold
environment, wait about two hours
before switching on!
We advise you to place the coffee
machine on a suitable mat to prevent
damage being caused by spray and
splashes.
0
Plug the coffee machine into an
earthed mains socket. Do not use a
socket that is not earthed.
5.2 Filling with water
Each time before switching on the cof-
fee machine, check that there is water
in the water tank, and refill if neces-
sary. The coffee machine requires water
for the automatic rinsing processes
each time the machine is switched on
or off.
0
Remove the water tank from the cof-
fee machine (Fig. 6). Before the tank is
removed, the steam nozzle must
always be positioned towards the cen-
tre of the appliance, otherwise the
tank cannot be removed.
0
Fill the water tank with fresh cold
water. Never exceed the MAX line.
3
Pour only fresh cold water into the
water tank. Never put in other liquids,
e.g. mineral water or milk.
0
Replace the water tank (Fig. 6). Press
the tank firmly in, to ensure that the
water tank valve opens.
3
To always be sure of obtaining a rich
coffee with a full aroma, you should:
– change the water in the water tank
daily,
– wash the water tank at least once a
week in normal washing-up water
(not in the dishwasher). Then rinse
with fresh water.
5.3 Filling the coffee bean container
0
Raise the lid of the coffee bean con-
tainer, and fill the container with fresh
coffee beans (Fig. 7). Then reclose the
lid.
822_949_387 ECG6200_Elux.book Seite 93 Sonntag, 27. Januar 2008 11:07 23