36 SOLVING PROBLEMS Built-in Cooking
Problem
Possible Cause
When a non fan mode is
selected the fan starts
• Most oven modes have a fast heat up function that uses the fan, oven fan element and grill
elements. Auto fast heat up can be overridden by selecting a temperature of 120°C or less,
allowing the function to start, then increasing the temperature to the desired level.
There is warm air coming from
the top of the oven door
• The oven is located under the control panel. When the oven is on, the air passes through this
vent. This venting is necessary for proper air circulation in the oven and good baking results.
Do not block oven vent.
The light stays on when the door
is closed
• An oven function has been selected.
• The light has been turned on at the control panel.
The light does not turn on when the
door is opened
• Oven light may need replacing.
Shelf or telescopic runner slides out
when door is opened
• Oven cavity is not level, you can perform a check using a level to verify this (refer to installation
section). If not level refer to installer.
Loose oven door seals
• The oven door seal is attached at each corner. it may seem like a loose fit, but when the oven
door closes it will function correctly.
solving problems
When you need information, service or replacements please quote:
1. Model Number
2. Serial Number: You can find these on the data plate, which can be seen when the oven door is open. If you need more
information, please contact the Customer Care Centre on 13 13 49 (Australia – Centre is open 8.00am to 5.00pm Monday
to Friday EST) or 0800 436 245 (New Zealand – Centre is open 8.00am to 5.00pm Monday to Friday). Only authorised
service centres should carry out servicing, otherwise warranty may be void. If you have a warranty or spare parts enquiry, you
should call the numbers listed on the back page.
Summary of Contents for CVE602
Page 37: ...Built in Cooking NOTES 37 notes ...