Electrolux 520003, Instruction Manual

Page: 15 / 47

8
D Transport, Loading/Unloading
and Storage
D1 Introduction
Special equipment with sufficient capacity must
be used for transportation (the machine is moved
from one place to another place) and handling
(the machine is transferred to another jobsite).
The machine must only be transported, handled
and stored by qualified people. They must be:
- technically trained and experienced;
- familiar with applicable laws and safety
regulations concerning application fields;
- have knowledge about general requirements
of safety;
- able to identify and avoid any possible
danger.
D1.1 Transportation: Instructions to
Carrier
Warning!
Don't stand under the load in the
height when loading/unloading. Don't
enter into the work area without
authorization.
Important Information!
The machine weight cannot
sufficiently keep its stability.
The transported load may be carried
under the following circumstances:
—
with brake applied;
—
at the time of acceleration;
—
when turning;
—
on a rough road.
D2 Handling
The machine should be unloaded and stored on a
properly flat area.
D2.1 Handling Procedures
For correct and safe lifting operation:
•
Use equipment type with suitable features
and capacity (e.g. electric pallet truck or
forklift);
•
Cover sharp edges;
•
Check forklift and lifting procedures
according to indications on the package.
Before lifting:
• All the operators must present at a safe
position. People not involved in operation
must not enter into the handling area;
• Ensure that the load is stable;
• Ensure that no material may be fallen
during lifting and ensure vertical operation
to avoid impact.
• When handling machine, ensure that the
distance between the machine and the
ground shall be kept as minimum as
possible.
Caution!
When lifting machine, don't use case,
wire channel, pneumatic elements
and other moving or weak
components as support.
D2.2 Handling
Operators must:
•
Have overall planning about handling path;
•
Stop operation under hazardous situation
D2.3 Load Bearing
Before placing load, ensure that the path is free
and the ground is flat to correctly bear load.
D3 Storage
The Machine and/or its components must be
stored in room temperature ranging from -10 to
50
℃
, without vibration and erosion to protect from