ELECTRO FREEZE Shake Model CS705
184592
40
PROBLEM
PROBABLE CAUSE
REMEDY
13 Troubleshooting Charts
— continued
1. Faulty head o-ring.
1.
Replace o-ring.
Mix leaking at
dispensing
head.
2. Head not properly installed.
2.
Install head properly. Replace o-ring if
pinched.
Mix or water
leaking from
drain tube to
drip tray.
1.
Damaged beater shaft seal or installed
improperly.
1.
Replace cup seal. Install properly.
Dispensed
product too soft.
(Product
temperature
above 28°F
[-2.2°C] )
1. D irty or blocked condenser, restricted
air flow.
1. Unblock condenser or have cleaned by
your Electro Freeze Distributor.
2. Torque control not set firm enough.
2. Contact your Electro Freeze Distributor for
service.
3. C omponent failure.
3. Contact your Electro Freeze Distributor for
service.
4. Leak in refrigeration system resulting in
little or no refrigeration.
4. Contact your Electro Freeze Distributor for
service.
Unit does not
operate.
1. Freezer
unplugged.
1. Plug
in
freezer.
2. Fuse or breaker blown at main disconnect.
2. Make sure your freezer is connected to a
separate circuit independent from any
other electrical equipment. Have
technician check fuse or breaker size and
check for low voltage; if not within 10% of
nameplate rating call power company.
3
Actuator rod not installed.
3. Install actuator rod.
4. Off on high pressure cut-out control.
4. Water turned off or defective water
regulating valve. Check water supply.
5. Circuit breaker tripped. .
5. Contact your Electro Freeze Distributor
for service
6. Faulty selector switch.
6. Contact your Electro Freeze Distributor
for service.
7. Disconnected or broken wire in electrical
circuit.
7. Contact your Electro Freeze Distributor
for service.
