Electrify America innogy eBox professional, Installation Instructions Manual

Page: 10 / 28

10
DOCK INSTALLATION INSTRUCTIONS
Before installing
Check and ensure that the electrical installation intended
for connection can supply the required electrical power.
Each Dock must be protected with its own circuit
breaker in the pre-installation. No additional electrical
devices may be integrated in any of these circuits.
Circuit breaker required for installation, and must conform to all
national and local laws, regulations, ordinances, codes and safety
standards. Licensed electrician performing installation should
choose correct circuit breaker depending on grid type and power.
Installation summary
1. Checks:
Make sure that the circuit breaker has been
installed in the sub-panel on the power supply circuit to
this device.
2. Power supply line:
The cable routing plates may have
to be switched over, depending on whether the supply
line is routed from the top or bottom.
3. Ethernet cable:
Before connecting an Ethernet cable
(optional), first drill a hole for an M20 thread according
to the enclosed cable gland through the corresponding
routing plate.
4.
Make sure that the
contact guard
is snapped into
place. Use the provided seal to secure the contact
guard on the Dock so that is is not possible to remove
the contact guard without breaking the seal.
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
THEY SHOULD BE PROVIDED TO EACH NEW OWNER.
INSTALLATION INSTRUCTIONS
DANGER
Danger of electrical shock
or injury. Before installing,
familiarize yourself with the
safety instructions. Follow
all federal, provincial and
local laws, regulations,
ordinances, codes and
safety standards.