Electra DCI 80, Service Manual

Page: 43 / 162

11-6
CONTROL SYSTEM
Revision Y05-02
Service Manual - WNG 50_60_80 DCI
Model J2 Shorted J2 Opened
Wall mounted Compensation Disabled Compensation Enabled
Cassette Compensation Enabled Compensation Disabled
Ducted Compensation Enabled Compensation Disabled
Floor/Ceiling Compensation Disabled Compensation Enabled
11.16 Indoor Fan Control in Heat Mode
Indoor fan speed depends on the indoor coil temperature:
11.17 Auto Cool/Heat Mode
When in auto cool heat mode unit will automatically select between cool and heat
mode according to the difference between actual room temperature and user set
point temperature (T).
Unit will switch from cool to heat when compressor is off for 3 minutes, and T <
-3.
Unit will switch from heat to cool when compressor is off for 5 minutes, and T < -3.
11.18 Dry Mode
As long as room temperature is higher then the set point, indoor fan will work in low
speed and compressor will work between 0 and
MaxNLOADIF1C Hz.
When the room temperature is lower than the set point, compressor will be
switched OFF and indoor fan will cycle 3 minutes OFF, 1 minute ON.
11.19 Protections
There are 5 protection codes.
Normal (Norm) – unit operate normally
.
Stop Rise (SR) – compressor frequency can not be raised but does not have to be
decreased.
HzDown1 (D1) – Compressor frequency is reduced by 2 to 5 Hz per minute.
HzDown2 (D2) – Compressor frequency is reduced by 5 to 10 Hz per minute.
Stop Compressor (SC) – Compressor is stopped.
ICTVL ICTH ICTL
ICTST
ICTT