ELCOS SRL
- Parma - CEM-120 – PROG – EN
8
MAINTENANCE
NOT EXPIRED
RESET
KILOWATT HOUR?
RESET STARTING
FAILURES?
RESET STARTUP
COUNTER?
MODIFY
HOUR METER
DELETE
MAINTENANCE 1?
0 s
RESET
KILOWATT HOUR?
RESET STARTING
FAILURES?
RESET STARTUP
COUNTER?
1 2 3 4 5h
DELETION OF EXPIRED MAINTENANCE OPERATIONS
RESETTING OF KILOWATT-HOUR.
RESETTING OF COUNT OF FAILURES TO START.
RESETTING OF START-UP COUNT.
CHANGE OF INDICATED HOURS.
When you change the value of the hour meter the preventive maintenance programming must be done again.
To delete press
simultaneously and wait for
PROGRAMMED to be written.
To reset press simultaneously and wait for
programmed to be written.
To reset press simultaneously
and wait for programmed to be written.
To reset press simultaneously
and wait for programmed to be written.
To reset press simultaneously
and wait for programmed to be written.
The warning light
goes out when all
the expired maintenance operations are
deleted.
Press to
display.
Press to
display.
Press to
display.
Press to
display.
PREVENTIVE MAINTENANCE
CHANGE RESETTING OPERATIONS
The control unit manages three fixed time notifications and a cyclic notification. Notifications 1, 2 and 3 are for a fixed
time and trigger only once, when the hour meter reaches the programmed value. Notification number 4 is cyclic and triggers after
the programmed hours and whole multiples of them. The request for maintenance is indicated: by the flashing of the hour meter,
the intermittent switching on of the yellow warning light and the message on the display.
Example 1: Notification 4 is programmed to 100. The notification triggers after 100, 200, 300, 400 ... hours.
Example 2: Notification 1 is programmed to 100. The notification triggers at 100 hours, and never triggers again.
The factory value for all the notifications is zero. The maintenance operations are programmed by the G.S. manufacturer during
testing. The maximum value is 59999 hours.
ACCESS TO PERIODIC PROGRAMMING
PREVENTIVE
MAINTENANCE 1
500h
NO
STOP
500h
NO
STOP
Decreases
Increases
Press when the arrow is
next to the value to be
increased
STOP,
when the maintenance has expired
it enables the general alarm and prevents
subsequent start-ups. NO STOP, enables
the general alarm for 10 seconds.
Press to
display.
Press again to change the number
of the maintenance operation 1 - 2 -3 -4 (cyclic)
Factory setting
Example
Zero hours of preventive
maintenance not activated
E
xPIRED
MAINTENANCE
OPERA
-
TIONS
ARE
CONSIDERED
FAULTS
Fault
codes
Alarms
111
Preventive
maintenance 1
112
2
113
3
114
4
1 2 3 4 5h
Press and
wait for the system
to write PROGRAMMED.
Press
to display.
Press again to change the
number of the expired
maintenance operation.