ELCOS SRL
- Parma - CIM-137/4G - 137/4GW - MAN - EN
14
• PROGRAM
TELEPH.GSM
see
USER PROGRAMMING
on page 18.
Should the unit indicate there is a problem with the motor pump, a message is sent to the first number. If
there is no answer, 10 minutes later a message is sent to the second number, and so on. Three numbers
can be set in total. The process continues for 4 times if none of the 3 users contacted sends an SMS reply
to the unit using the phrase OK. Any subsequent problems with the pump result in the SMS notification
process being started again.
N.B.: It is possible that, once one of the 3 users has sent an OK message to the unit, another error mess-
age may be sent to the second user. This is due to delays caused by traffic on the telephone network and
is outwith the control of the unit.
TO CONFIRM RECEPTION OF THE
SMS WARNING MESSAGE
AND
STOP THE SENDING OF SUBSE-
QUENT
MESSAGES, SEND A MESSAGE FROM YOUR CELL PHONE USING THE PHRASE
OK.
After confirmation,
the
display
will
show
Decreases
Increases
Press to
write the number
left
right
Moves the cursor
CHOICE OF
SUBSCRIBER
WRITE THE MOBILE
PHONE NUMBER
CONFIRMATION
Example
or 2 - 3
NUMBER
SUBSCRIBER
MOBILE
PHONE
NUMBER
Cursor
that
flashes
Indicates
that the
number
continues
right >
< left
Push to view
the first,
second
or third
subscriber.
Press and
wait for
OK to be
written.
MOB. 1
MOB. 1
-123456789>
333456789
NOTIFIED
MOB. 1
333-
Notifies via SMS message when the motor pump is in alarm condition
Programming the cell phone numbers of the users who are to be notified when the motor
pump is in alarm condition
IMPORTANT NOTE
In order for a command sent via SMS to be interpreted
correctly, it is important to programme the telephone number exactly as it is
given by the mobile telephone network, and therefore inclusive of international
dialling code and without the first zero of the dialling code (if there is one) of
the telephone company.
Ex1: Italian number = 348123456
programme
+ 39348123456
Ex2: English number = 0797123456 (leave out the 1st zero)
programme
+ 44797123456
In any case, refer to the national numbering system.
When the SMS TO ALL PHONES INCLUDED function is used (factory setting, see page 20 of the
technical programming manual) the SMS fault messages are sent only to the telephones programmed in
the list of telephone numbers of the control unit. For example: an operator who starts the motor pump from
their mobile phone, and does not have their telephone number programmed in the list of telephone num
-
bers, will NOT receive the SMS message in the event of a fault. But it will be received by the telephone
with its number programmed in the CIM control unit following the procedure described later.