59
Actuator Type ARIS, 4, 4a, 5
Description
The actuator type ARIS-N is designed
as a controlling element for oil/gas or
dual-fuel burners with sliding or modula-
ting control concept. The actuator is
equipped with a short-circuit-proof syn-
chronous a.c. motor which drives a
shaft via a maintenance free spur-gear
unit with permanent grease lubrication.
The shaft end carries a coupling for
operating the controlling element for
fuel and combustion air. The actuator is
designed for two-wire control by control-
lers or switching units with change-over
contact (single-wire control is possible).
A feedback potentiometer is used as a
optional feature.
Technical Data:
Voltage:
230 V +/- 10%
Protection class:
IP 54, DIN 400 50
Frequency:
50 Hz (60 Hz)
Installation position: no restriction
Operating time:
25 - 30 sec. at 90°
Torque:
N 4 40 Nm
N 4A 60 Nm
N 5 110 Nm
Weight:
N 4 3,4 kg
N 4a 3,4 kg
N 5 5,8 kg
Contacts:
max. 250 V 10(3)
A
Ambient
temperature:
-15 °C till + 60 °C
Adjustment
A service switch for manual/automatic
operation is provided for adjusting the
actuator/controlling element.
This service switch comprises:
1x
manual/automatic tumbler switch
1x
left/right pushbutton switch con-
nected according to the sketch
(left)
For using the actuators with service
switch (no handwheel) care should be
taken to observe the following:
• An additional permanent phase must
be installed from the actuator to the
control cabinet via the terminal box or
directly to the control cabinet.
• An additional terminal must be moun-
ted in the terminal box.