33
J
Fig. 8.4
Fig. 8.5
REPLACEMENT OF THE
INJECTORS
If the injectors are not supplied they can
be obtained from the “Service Centre”.
Select the injectors to be replaced
according to the “Table for the choice of the
injectors”.
The nozzle diameters, expressed in
hundredths of a millimetre, are marked on
the body of each injector.
REPLACEMENT OF THE INJECTORS
OF THE COOKTOP BURNERS
To replace the injectors proceed as follows:
•
Remove pan supports and burners
from the cooktop.
•
Using a wrench, substitute the nozzle
injectors “
J
” (fig. 8.4) with those most
suitable for the kind of gas for which it
is to be used.
The burners are conceived in such a
way so as not to require the regulation
of the primary air.
ADJUSTING OF THE MINIMUM OF
THE TOP BURNERS
Considering that in the minimum position
the flame must have a length of about 4 mm
and must remain lit even with a brusque
passage from the maximum position to that
of minimum.
The flame adjustment is done in the
following way:
•
Turn on the burner.
•
Tum the tap to the MINIMUM position .
•
Take off the knob.
•
With a small flat screwdriver turn the
screw inside the tap rod to the correct
regulation (fig. 8.5).
Normally for LPG (G30/G31), tighten up
the regulation screw.
Summary of Contents for S 61 X 631 F
Page 2: ...2...
