
32
REPLACING THE OVEN LAMP/S (MODELS WITH HALOGEN LAMP/S)
WARNING: Ensure the appliance is switched off before replacing the lamp to avoid
the possibility of electric shock.
•
Let the oven cavity and the heating elements to cool down.
•
Switch off the electrical supply.
TOP RIGHT LAMP:
•
Remove the protective cover “
C
” (fig. 2.10b).
•
Replace the halogen lamp “
B
” with a new one suitable for high temperatures (300°C)
having the following specifications: 220-240V, 50/60Hz and same power (check watt
power as stamped in the lamp itself ) of the replaced lamp.
IMPORTANT WARNING:
Never replace the bulb with bare hands; contamination from
your fingers can cause premature failure. Always use a clean cloth or gloves.
•
Refit the protective cover.
LEFT LAMP (SOME MODELS ONLY):
•
Remove the left wire rack (and the side catalytic panel for the models with side catalytic
panels) by unscrewing the fixing screws.
•
Press down from the top the protective cover “
A
” (fig. 2.10b) and remove it by rotating
on the lower side.
IMPORTANT:
never use screwdrivers or other utensils to remove
the cover “
A
”. This could damage the enamel of the oven or the lampholder.
Operate only by hands.
•
Replace the halogen lamp “
B
” with a new one suitable for high temperatures (300°C)
having the following specifications: 220-240V, 50/60Hz and same power (check watt
power as stamped in the lamp itself ) of the replaced lamp.
IMPORTANT WARNING:
Never replace the bulb with bare
hands; contamination from your fingers can cause premature
failure. Always use a clean cloth or gloves.
•
Refit the protective cover “
A
” operating in reverse order.
ATTENTION:
the notch in the inner edge of the cover must
be oriented toward the lamp.
•
Assemble the left wire rack (and the side catalytic panel with
the arrow up for the models with side catalytic panels).
Note: Oven bulb replacement is not covered by your
guarantee.
Fig. 2.10b
A
B
B C
1
2 A
A
WRONG
CORRECT