Elba DOMINO E35-200 XD, Instructions For The Use - Installation Advices, Page: 9 / 32

9
FASTENING THE INSTALLATION BRACKETS
(figs. 1.3a, 1.3b, 1.3c)
Each cooktop is provided with an installation kit including brackets and screws for fastening
the cooktop to benches from 20 to 40mm thick.
The kit includes two “ F ” type brackets (for the front of the cooktop), two “ R ” type brackets
(for the rear of the cooktop) and four self-threading screws “ S ”.
The kit includes 4 tabs “ A ” and 4 selfthreading screws “ B ”.
•
Cut the unit.
•
Stretch gasket “ G ” over the edge of the hole made, being careful to overlay the junction
edges (fig. 1.2b).
•
Turn the cooktop over and put tabs “ A
” (fig. 1.2a) into the mountings, only tighten
screws “ B ” a few turns. Make sure that the tabs are mounted correctly as shown in the
figure 1.2c. Turn the tabs so that the cooktop can be put into the hole.
•
Put the cooktop into the hole cut into the unit and position it correctly.
•
Put tabs “ A ” into place, tooth “ C ” of the tabs should go into the hole.
•
Tighten screws “ B ” until the cooktop is completely secured.
•
Using a sharp tool cut off the part of gasket “ G ” which protrudes from the cooktop.
Take care not to damage the benchtop.
Fig. 1.3c
Fig. 1.3a
G
Fig. 1.3b
A
A
A
A
20
mm min.
40
mm max.
B
D
A
C
A
A
A
A