Elba DOMINO E35-200 XD, Instructions For The Use - Installation Advices, Page: 14 / 32

14
Floating nut
Brass elbow
1/2” G cylindrical
(ISO 228-1) male
1/2” G cylindrical
(ISO 228-1) male
1/2” G cylindrical
(ISO 228-1) female
Turning the gas
connection fitting
DO NOT USE the
brass conical
connector
(supplied with
the product in a
separate kit)
1/2” G cylindrical
(ISO 228-1) female
Rigid pipe
(not supplied) Flexible hose
(not supplied)
Appliance
inlet pipe
After connecting the appliance to the gas supply, make sure that you
•
check that the connections are correctly sealed using a soapy solution, but never a
naked flame.
•
check whether the injectors are correct for the type of gas being used. If not, follow the
instructions under “GAS MAINTENANCE”.
•
replace the sealing washer/s on the slightest sign of deformation or imperfection. The
sealing washer/s is/are the part/s which guarantee/s a good seal in the gas connection.
GAS CONNECTION WITH RIGID PIPES OR A FLEXIBLE HOSE (NATURAL
GAS OR LPG ONLY)
The gas connection fitting (fig. 2.2) is made up of:
•
the appliance inlet pipe;
• the floating nut;
•
the brass elbow;
•
the sealing washers.
Important!
■ If fitted, remove the hose holder from the terminal fitting of the inlet pipe.
■ Do not fit the brass conical connector, supplied with the product in a separate
kit, to the brass elbow.
Gas connection with rigid pipes or a flexible hose
(Natural Gas or LPG only)
Note: if already fitted on the inlet pipe, remove the rubber hose holder
Fig. 2.2
1/2” BSP
taper (conical)
(BS EN 10226-1)
male
Sealing washer
Sealing washer