see the number of the current Cue in the bottom left-hand corner of the screen.
Use the command line interface (CLI) to change the value of the channel. The CLI is known from
theatre lighting consoles and provides a fast way of setting values for one or multiple channels.
Examples of the CLI's usage are:
Command
Function
1 @ 50 <ENTER>
Sets channel 1 at 50% (or at DMX value 50 when DEC unit is
selected)
1 + 2 @ <FULL>
Sets channel 1 and 2 at maximum value
1 <THRU> 3 @ 0
Sets channels 1 till 3 at minimum value
1 <THRU> 3 + 5 @ 0
Sets channels 1, 2,3, and 5 at minimum value
<ALL> @ 100 <ENTER>
Sets channels 1 till 1024 at 100% (or at DMX value 100 when
DEC unit is selected)
1 @ + 10 <ENTER>
Increases channel 1 value with 10
<ALL> @ – 20 <ENTER>
Decreases all channels' value by 20
Capture a Cue
Alternatively to programming a Cue through the CLI it is also possible to record a Cue from the
DMX input port or incoming Art-Net universes.
To capture from DMX, simply connect your external DMX-512 source and set it to output the
desired Cue, then press the DMX Capture button. Only the first 512 channels will be recorded,
channels 513 till 1024 are left unchanged.
For capturing from Art-Net please make sure that the universe settings for incoming Art-Net match
the universes at your Art-Net source. Press the Art-Net Capture button and all 1,024 channels are
recorded in the Cue.
Timing
You can specify the cross-fade time between two Cues by setting the Cue's fade time. Also you
can determine for how long the Cue should be active before advancing to the next Cue by setting
the hold time. If the hold time is set to 0, the Cue is set to Halt and will not automatically go to the
next Cue.
12