ages of 3 and 8 must not be allowed to plug in, adjust or
carry out maintenance on the equipment.
• The product is not intended for use by persons (including
children) with diminished responsibility, reduced physical or
mental capacity, or lack of experience and knowledge, unless
they have been shown the use of the product or instructed
in its use by a person who is responsible for their safety.
• However, the product is suitable for use in situations where
there are persons (including children) with reduced physical
or mental capacity or diminished responsibility present.
• If children are in the proximity of the product, they must
be informed that the product must not be used as a toy or a
plaything.
WARNING Parts of this equipment can get very hot and
could cause burns. Take special care when children or vulnerable
people are present.
Safety during service/maintenance
Disconnect the heater fan from the electrical supply before
servicing or maintenance.
Warning/note
Leave the heater fan switched off for a while before servicing
so that it has time to cool down.
MINIMUM EXPERTISE REQUIRED
Any servicing and installation work must be performed by a
qualified professional.
RISK ASSESSMENT
Do not install the heater fan so that the air inlet or outlet is
blocked. Do not install directly underneath a fixed wall outlet.
If VFBR 9F2 has not been used for an extended period,
blow it clean to remove dust and dirt before switching it
on.
NOTE! Do not cover the heater fan.
SAFETY
Warning signs on the product
The manufacturer guarantees that this product fulfils safety
requirements in accordance with the relevant EU directives and
standards.
EU Declaration of Conformity, see www.elbjorn.com.
Safety during assembly
The heater fan must be connected to the electrical supply by a
qualified electrician. Make sure that the blower can be isolated
from the electrical supply to permit maintenance, by means of
an isolating switch for example. Always connect via a residual
current device.
Safety during use
• Do not cover the heater fan. Never remove guards, panels
or cover plates during operation. Do not allow children
under the age of 3 near the equipment unless they are
constantly supervised.
• Children between the ages of 3 and 8 should only be
allowed to turn the equipment on/off if it is installed in
its normal position and they have been instructed how to
use it safely and understand the risks. Children between the
137344
14
GB
100mm
mm
100
Min
Min
Min
1800mm
114061
WARNING!
The unit’s air inlet and outlet must never be
covered during operation.
Safe distances
Read the instruction manual carefully and make
sure you understand the contents before using
heater fan VF 9F2, VF 15F2, or VFBR 9F2.
INTRODUCTION
DESCRIPTION
VF 9F2, VF 15F2 and VFBR 9F2 are all referred to in this section as the heater fan.
The section on safety must be read and understood by everyone who uses or repairs the heater fan.
The instruction includes operation and maintenance measures that can be performed by the operator. More detailed service or
trouble shooting shall be performed by the manufacturer’s service personnel. The instructions describe all necessary safety features
and must be read and understood by the user before connecting the heater fan to the electrical supply. In other words, the first
thing the user should do after delivery is to read the user instructions. Symbols and warning signs that appear in these instructions
and on the heater fan are shown under SAFETY.
If any of the warning signs on the heater fan have become damaged or worn, new signs must be ordered as quickly as possible in
order to ensure the greatest possible safety when using the heater fan.
The heater fan may only be used for the purposes described in these instructions.
The manufacturer reserves the right to make changes.
Heater fan models VF 9F2, VF 15F2 and VFBR 9F2 are intended for permanent installation on a wall. The housing is made
of galvanised steel finished with epoxy paint.
An axial universal motor blows air through the fan housing. The stainless steel tubular element is cooled by the air flow from
the fan. The inlet and outlet are protected by finger guards.
An external switch box is used for control. With mechanical thermostat for room temperature control.
