SURFACE MOUNT LEDFIRE III EMERGENCY INSTALLATION INSTRUCTIONS
DRAFT
M5
TORQUE TO
1.5 NM MAX.
5. moUnting oPtions
1.
Remove the Surface Mount Ledfire III cover as shown in the installation instructions in
section 4 (page 3)
of this instruction manual. This will allow the mounting holes to become visible.
2.
Mount the Surface Mount Ledfire III by fastening screws securely to a flat surface.
Refer to installation guide (
Ev-RODMOUNT
) included in the rod mount kit. The product and rod MUST BE
dry and clean before assembly to avoid joint contamination.
1.
Disassemble the Surface Mount Ledfire III as shown in the installation instructions in
section 4 (page 3)
of
this manual. This will allow for the rod mount to be assembled to the products top cover.
2.
Ensure rod is mounted
ONLY
on a flat surface and fasten with the appropriate fixing e.g. masonry anchor
for concrete.
3.
A 25 tube is to be used, pushed firmly in on both ends and fastened.
SURFACE MOUNT
ROD MOUNT
Figure 2: Surface mount installation
Figure 3: Rod mount installation
NOTE:
DO NOT
overtighten screws when
mounting the rod mount to the Surface
Mount Ledfire III.
The rod mount is suitable with tubes
ranging from 0-2 metres in length. The
weight on the rod must not exceed 8kg.
M5 Philips screw/
locknut detail
Rod mount
25 tube
4
