DRAFT
4. installation
The Ektor Surface Mount Ledfire III can be installed either by surface or rod mounting the product.
To install the Surface Mount Ledfire III please follow the steps listed below:
1.
Remove the product from the box and inspect it for any damage. If you believe the product to be
damaged or otherwise unsound,
DO NOT
install the product. Please pack it back into its box and return
it to the place of purchase for replacement. If the product is satisfactory, proceed with the installation.
2.
When mounting the Surface Mount Ledfire III the cover
MUST
be removed. Remove the cover using a
flat blade screwdriver to release the clips and pull the cover upwards as shown below.
3.
The cover must also be removed for battery replacement and servicing. All installation options can be
found in the following section of this manual.
NOTE:
Ensure the Surface Mount
Ledfire III clips are released with a flat
blade screwdriver before attempting
to remove
Surface Mount
Ledfire III cover
Surface Mount
Ledfire III enclosure
Battery
2
3
Figure 1: Surface Mount Ledfire III disassembly and installation
3
