EKOM DK50 2V/M MOBILE, User Manual

Page: 8 / 240

GENERAL INFORMATION
NP-DK50 2V-A-4_10-2022-AD 8 10/2022
4. GENERAL SAFETY INSTRUCTION
The product is designed and manufactured so that any risks connected with its use are minimized
and the product is safe for the user and surrounding when used according to the intended use and
the instructions stated below are followed.
4.1. Required qualification if the personnel

Each user must be trained by the manufacturer or an organization authorized by the
manufacturer or instructed on the device operation by other trained user.

Installation, new settings, changes, extensions and repairs of the product may be performed
by the manufacturer or an organization authorized by the manufacturer (hereinafter qualified
technician).
- Otherwise the manufacturer is not responsible for safety, reliability and correct functioning
of the product.
4.2. General instruction

When operating the compressor, all acts and local regulations valid in the place of use must
be observed. The operator and user are responsible for following the applicable regulations.

Before every use, the user must check, if the device is functioning correctly and safely.
Before building the compressor in other devices, the supplier must assess, if the supplied
air and construction of the device comply with the requirements of the specified intended
use. Taking this into account, follow the product technical data. Assessment of conformity
shall be performed by the manufacturer
– supplier of the final product.
4.3. Protection from dangerous voltage and pressure

The device can be connected only to a properly mounted socket with protective earthing.

Before connecting the product, check if mains voltage and mains frequency stated on the
product are in compliance with the values of the mains.

Before putting the product into operation, check eventual damages to connected pneumatic
hoses and electrical cables. Replace damaged pneumatic hoses and electrical cables
immediately.

Immediately disconnect the product from the mains (pull out the mains plug) in hazardous
situations or technical disorders.

Safety valve settings must not be changed and used to depressurize the air tank.
4.4. Original spare parts and accessories

Safety of operating staff and failure-free operation of the product are guaranteed only when
original spare parts are used. Only accessories and spare parts stated in the technical
documentation or expressly approved by the manufacturer may be used.

The guarantee does not apply to damages arising from use of accessories and spare parts
other than prescribed or recommended by the manufacturer and the manufacture is not
responsible for them.