EKKO EK18RF, Service Manual

Page: 27 / 31

26
Vehicle fault reading process:
1. After connecting the handheld unit with the controller, open the key switch
2, From the menu list of CURTIS handheld units, find: Faults...
3. When the vehicle is running and the hand-held cursor flashes, there will be English fault content,
which can be interpreted by referring to the fault code table
Vehicle signal detection:
1. After connecting the handheld unit with the controller, open the key switch
2, According to the menu list of CURTIS handheld unit, find: Monitor......
3. According to requirements, open the corresponding sub-item of the detection menu, run the vehicle,
and observe the change of the hand-held value.
CURTIS Contents of handheld unit menu:
The Curtis 1313 handheld programmer is used to configure the Curtis electric control system. Through
this programmer, you can adjust and save the set parameters, real-time monitoring of controller data and
fault diagnosis
The programmer has two interfaces, one is used
to communicate with the electric control, the
other is used to communicate with the PC, the programmer has a battery box and a memory card slot
Warning: The control system can affect the vehicle's
acceleration rate, deceleration rate, hydraulic system
and braking. A dangerous situation can occur if the
vehicle control system is not programmed correctly
or exceeds safety. Only the vehicle manufacturer or an
authorized service agent can program the control
system