EKKO EK18RF, Service Manual

Page: 10 / 31

9
32
Relay Welded
1. In RegEN mode, the battery or battery cable resistance is too
high
33
Relay Did Not Close
2. The battery cable is disconnected during regen
34
Hardware Fault
1. Vehicle overload
35
Fault Output Failed
2. The controller runs in an ultra-high temperature environment
36
Motor Stalled
1. Vehicle overload
37
Motor Open
1. Open cables to the steering motor
38
Motor Short
2. The motor is incorrectly connected
41
Command Analog1 Out of
Range
3. The controller fails
42
Command Analog2 Out of
Range
1. The steering motor is short-circuited
43
Feedback Analog1 Out of
Range
1. Analog input 1 (J1-6) is out of range
44
Feedback Analog2 Out of
Range
2. Low end of instruction (J1-14) out of range (for resistance
type)
45
Parameter Change Fault
3. The parameter Settings are incorrect
46
EEPROM Failure
1. Analog input 2 (J1-13) is out of range