32
3. When the vehicle is running and the hand-held cursor flashes, there will be English fault content,
which can be interpreted by referring to the fault code table
Vehicle signal detection:
1. After connecting the handheld unit with the controller, open the key switch
2, According to the menu list of CURTIS hand held unit, find: Monitor......
3. According to requirements, open the corresponding sub-item of the detection menu, run the vehicle,
and observe the change of the hand-held value.
CURTIS Contents of hand held unit menu:
The Curtis 1313 hand held programmer is used to configure the Curtis electric control system.Through
this programmer, you can adjust and save the set parameters, real-time monitoring of controller data and
fault diagnosis
The programmer has two interfaces, one is used to communicate with the electric control, the other is
used to communicate with the PC, the programmer has a battery box and a memory card slot
Warning: The control system can affect the vehicle's
acceleration rate, deceleration rate, hydraulic
system and braking.A dangerous situation can
occur if the vehicle control system is not
programmed correctly or exceeds safety.Only the
vehicle manufacturer or an authorized service agent
can program the control system
Summary of Contents for EK07S Series
