- 16 -
- 16 -
- 16 -
1
、
The wheel bearing
2
、
The door frame
3
、
Chain
4
、
Hydraulic system
5
、
Steering bearing
6
、
Gear box
7.3. inspection and hydraulic oil refill needed hydraulic oil type
Anti-wear hydraulic oil 32#
Viscosity is 32 - 38
Based on the model, the amount of oil is from ~2.5L to 3.0L.
Waste materials such as waste oil, waste batteries or other materials must be recycled
according to national law.
7.4. check the electrical fuse
7.5. Removed
install the protective net, if the protective device is damaged or is not installed properly, do
not use this car!
If you need to remove protective net, unscrew the screw fixation and remove protective net.
Screw is still in the protective net. Re installation, the protective plate placed in the correct
position and the right fixed each screw. If you need to change parts, please contact your
nearest after sale service partner.
8.Fault analysis
If the vehicle to follow the instructions of the sixth chapter explains, still failure.
Table Failure analysis of 6:
Fault
Reason
Repair
The goods cannot ascend
Excessive weight
Only increase the maximum load
capacity is shown on the nameplate
Battery discharge
Battery charging
Enhance the fuse failure
Check and the eventual
replacement of ascending fuse
The hydraulic oil level too low
Check and finally filled with
hydraulic oil
The oil spill
Seal repair tubing and / or cylinder
Not oil
Oil is too high
Reduce oily
The goods cannot be
Oil dirty blocking control valve
Check the hydraulic oil and
cleaning control valve. Replace the
hydraulic oil if necessary
