Technical Information C41-CFAST • CFast™ Card SATA USB Mezzanine Module
J-USB3
As a custom specific option, the C41-CFAST can be provided with one USB receptacles. Due to the
USB connector dimensions, the total stack height of the CPU carrier board and the C41-CFAST
mezzanine module assembly will exceed the 4HP envelope about ~1.3mm. This may be tolerable in
some situations, but should be nevertheless considered. USB cable assemblies with slim and short
plugs are also required - not any USB harness matches with the C41-CFAST due to space restrictions.
The same issue must be strictly observed if direct attachment of an USB stick (e.g. Flash Drive) is
intended - only a very short, low profile stick (with an overall length of less than 50mm) would be
suitable.
The J-USB3 receptacle cannot be populated together with the UFD1 Flash module, since both
components would overlap each other.Be sure to discuss your needs with [email protected] before
ordering.
The C41-CFAST USB port are derived from the ICH southbridge on the CPU carrier board. A dual
electronic switch is provided on the C41-CFAST for short-circuit and overcurrent control regarding the
J-USB3 receptacle (0.5A).
USB Receptacles J-USB3 & J-USB4 • 270.20.04.0
1) Dual Channel Electronic Switch Protection
1
+5V_USB 0.5A 1)
2
DATA-
3
DATA+
4
GND
USB Receptacle
© EKF •
ekf.com
270.20.04.0 •
© EKF -23- ekf.com
