Technical Information C41-CFAST • CFast™ Card SATA USB Mezzanine Module
P-SATA2 P-SATA3
The C41-CFAST can be optionally stuffed with two vertical latched SATA signal headers. TX/RX
designation of signals are shown with respect to the SATA controller. P-SATA2 corresponds to the
SATA channel 0 of the JMB362 controller on the carrier board, and P-SATA3 is wired to the JMB362
SATA channel 1. The SATA ports can be used individually or as RAID 0/1.
Latching cable assemblies are recommended for reliable industrial usage. Both on-board SATA
headers are aligned so, that a cable assembly with R/A plug leads to the rear side (opposite side with
respect to the front panel), for system internal attachment of SATA drives.
Usage of P-SATA2/3 exceeds the 4HP total height of the board assembly (carrier board together with
C41-CFAST mezzanine) by ~10mm, a cable harness with R/A SATA plug assumed. This is not tolerable
for an additional 4HP mezzanine expansion card such as the CCL-CAPELLA or the CCI-RAP. Discuss
your actual needs with [email protected] before ordering.
P-SATA2 P-SATA3 #256.007.22.01 Latched Headers
1
GND
2
3
SATA_TX-
4
GND
5
SATA_RX-
6
7
GND
Latched SA
TA
Header
256.007.22.01 © EKF ekf
.com
© EKF -21- ekf.com
