eka EKF 523E UD, Instruction Manual

Page: 9 / 23

Electronic Ovens rev. 0 _________________________________________________________________EKF 523 E UD
_________________________________________________________________________________________ page 9
8) Connect the tube (6) with filter and ballast (included in “Pump kit”) to pump’s apron (7).
9) Replace back cover.
Fig.
Fig. Fig.
Fig.3
3 3
3
Warning:
Warning: Warning:
Warning:
To avoid limestone buildup into the cooking chamber, we suggest to fill the water tank with
decalcified water.
Check water level in the tank before activating the pump and during its functioning. If pump Check water level in the tank before activating the pump and during its functioning. If pump Check water level in the tank before activating the pump and during its functioning. If pump Check water level in the tank before activating the pump and during its functioning. If pump
works without water in the tank, what occurs is abnormal noise at first
works without water in the tank, what occurs is abnormal noise at first works without water in the tank, what occurs is abnormal noise at first works without water in the tank, what occurs is abnormal noise at first and then its breakage and then its breakage and then its breakage and then its breakage
....
Connection of power cable
Connection of power cable Connection of power cable
Connection of power cable
The terminal board is on the rear panel of the appliance. Open the terminal board cover by
obtaining leverage with a screwdriver on the two side fins. Loosen the cable gripper screw and
allow the cable to pass through it. Arrange the conductors so that the earth conductor is the
last to detach from its terminal if the cable goes into a state of faulty traction. Connect the
phase
phase phase phase conductor to the terminal marked with the letter "L" "L" "L" "L", the neutral neutral neutral neutral conductor to the
terminal marked with the letter "N"
"N" "N"
"N" and the earth
earth earth
earth conductor to the terminal marked with the
symbol . Tighten the ring-nut of the cable gripper and close the terminal board cover. The
appliance must be connected to an equipotential system
equipotential system equipotential system
equipotential system whose efficiency must first be checked
according to current legal regulations. This connection must be made between different
appliances by using the appropriate terminal marked with the symbol
. The equipotential
conductor must have a minimum diameter of 2,5mm
2
The equipotential terminal is at the rear
of the appliance.
Safety thermal breaker
Safety thermal breaker Safety thermal breaker
Safety thermal breaker
The appliance has a manually reset safety thermal breaker. It protects against excessive
dangerous over-temperatures which could be accidentally generated inside the appliance. If the
device is tripped, it interrupts electrical power to the appliance and thus prevents it from
operating.